DGLAB-I032
DGLAB_i032_CAN
What does DGLAB-I032 mean?
Tesla info code in the DGLAB (DGLAB) module. CANmessage ETH_DAS_STATUS_MID from DAS not received by the UI whilst drive rail ON or Cruise state went to FAULT when Autopilot was active or Autopilot state changed from ACTIVE to FAULT Cruise & Autopilot resume standard operation Cruise or Autopilot unavailable Ecall self-test has failed after 3 retries Ecall self-test has failed after 3 retries. Alert triggers when drive rail turns ON File /var/run-overlay can alter the behavior of a developer vehicle Steering module (EPAS3P or EPAS3S) detected a fault or reduced assistance whilst drive rail is on Steering module (EPAS3P or EPAS3S) detected a fault or reduced assistance whilst drive rail is ON Steering module (EPAS3P or EPAS3S) resume stabdard operation or drive rail turns OFF Steering assistance is reduced or inoperational Display status check failed due to touch device missing. The /dev/input/touch directory is not accessible. The /dev/input/touch directory has to be accessible. Touchscreen is unresponsive or has limited functionality. Rear trunk open when gear is D/R/N Shift into Park or close rear trunk or timer of 60 seconds elapsed Potential danger of open trunk whilst driving Software running on the modem has crashed (ModemVM) Navigation map data is missing and the corresponding file system was not mounted. Install latest map data Navigation map data not found and the corresponding file system mount status is unknown. Try to install latest map data. Navigation routing inoperative. The QtCarVehicle link has stalled. Unable to communicate with vehicle Gateway
Original Description
CANmessage ETH_DAS_STATUS_MID from DAS not received by the UI whilst drive rail ON or Cruise state went to FAULT when Autopilot was active or Autopilot state changed from ACTIVE to FAULT Cruise & Autopilot resume standard operation Cruise or Autopilot unavailable Ecall self-test has failed after 3 retries Ecall self-test has failed after 3 retries. Alert triggers when drive rail turns ON File /var/run-overlay can alter the behavior of a developer vehicle Steering module (EPAS3P or EPAS3S) detected a fault or reduced assistance whilst drive rail is on Steering module (EPAS3P or EPAS3S) detected a fault or reduced assistance whilst drive rail is ON Steering module (EPAS3P or EPAS3S) resume stabdard operation or drive rail turns OFF Steering assistance is reduced or inoperational Display status check failed due to touch device missing. The /dev/input/touch directory is not accessible. The /dev/input/touch directory has to be accessible. Touchscreen is unresponsive or has limited functionality. Rear trunk open when gear is D/R/N Shift into Park or close rear trunk or timer of 60 seconds elapsed Potential danger of open trunk whilst driving Software running on the modem has crashed (ModemVM) Navigation map data is missing and the corresponding file system was not mounted. Install latest map data Navigation map data not found and the corresponding file system mount status is unknown. Try to install latest map data. Navigation routing inoperative. The QtCarVehicle link has stalled. Unable to communicate with vehicle Gateway
Severity Notes
DGLAB-I032 is a diagnostic or informational code in the DGLAB system. Typically no immediate action is required.